Assuming you are involving coat holders for your wire, utilize the pliars to loosen up the coat holders and stretch the wire out semi-straight. Then, utilizing the pliars and your hands, wind the wire around the neck of the container no less than once and give the wire a little curve around itself toward the finish to get it around the neck of the container. Rehash this for each container that you have. Then, utilizing your pliars, wind the opposite finish of the wire firmly around the screw once. Then, at that point, utilizing your drill or a screwdriver embed the screw into an above crossbeam of your yard – I draped these lights over my open air deck table.
You want to practice alert and not embed screws that are long an adequate number of that they will go through the yard rooftop and cause a release or cause other damage…also remember that you will utilize candles so ensure your wire is long enough so the rising intensity from the light would not burst anything into flames. When the lights are gotten, twist the wire between the roof and bar in a contorted or crisscross example – or on the other hand in the event that you favor fix it – and twist the wire at the neck of the container so the container is hanging level. Then, at that point, drop a tea light utilize the ones that are in the little metal holders into each container and light the tea lights utilizing a rotan lampenkap long flame lighter to stay away from consumes. In the event that you favor you can paint stars, blossoms or different plans outwardly of the jars I utilized the old blue-is antique Ball containers and they add a rural dated appeal to my back patio and give a pleasant light over the table. I have four of them hanging in a gathering at different lengths.
In the event that you are setting up a hanging lamp, this is an ideal opportunity to add the chain and the extra wire so it hangs where you need it. Utilizing the forceps first add the extra chain. You should simply open one of the connections add the new chain and close it up once more. To add the electric wire, strip around one inch of plastic cover from each wire and tie it firmly with the wire previously joined to the lamp. Cover each exclusively with electric tape and add another layer covering the two wires together. Bring down the first lamp and saved it, raise the upgraded one and tie every lamp wire to one of the wires hanging from the roof. It does not make any difference which wire you attach with each wire on the roof, the lamp will work in any case.